[Jason Manning]

This is killing me cause my YesWelder MIG-205DS wire feeds jerky, Using 0.035-inch wire at 24V, and welds is uneven. what is wrong?

[Scott Whitaker]

Jerky feed comes from bad tension or rollers, Adjust drive roll tension on MIG-205DS, My YesWelder had same issue, Use 230 ipm wire speed, Clean liner with alcohol, Check for wire kinks, Set voltage to 22V, Replace worn rollers.

[Teresa Tucker]

uneven welds comes from worn drive rolls, Replace them for steady feeding, My YesWelder feeds smooth now, Check spool tension for balance.

[Jennifer Smith]

Try looser spool tension, it helps with feeding.

[Henry Jackson]

Use 0.030-inch wire, it reduces drag and jamming.

[Michael Graves]

Check liner condition, clogs causes jerky feeding.

[Author]

Posts