[Michelle Burke]

To all community members, in a trouble cause my YesWelder MIG-205DS burns through thin steel, Using 0.035-inch wire at 24V, and welds burns through easy. any settings?

[James Edwards]

burn-through comes from high heat settings, Lower to 16V for better control, My YesWelder welds thin steel smooth now, Clean metal with acetone.

[Kimberly James]

Holes mean excessive heat on steel, Set MIG-205DS to 18V for control, Use 0.030-inch wire for better results, My YesWelder burned through too, Clean with alcohol, Set wire speed to 220 ipm, Use 20 CFH argon, Use pulse mode.

[Emily Simmons]

Try pulse mode for thin steel, it helps.

[Author]

Posts