[Regina Brown]

To all community members, I am a little bit confused cause my Weldpro Digital TIG 200GD wire feed jams on mig with 0.035-inch mig wire at 20V, it’s a real pain. How i can avoid this problem?

[Joseph Ellis]

Replace contact tip on your Weldpro Digital TIG 200GD, worn tips cause wire jams, use 220 ipm.

[Linda Lowe]

Clean liner with alchohol on your Weldpro Digital TIG 200GD, dirty liners jam mig wire, set tension to 3.5.

[Richard Jackson]

Check spool tension on your Weldpro Digital TIG 200GD, too tight causes wire jams, set voltage to 19V.

[Author]

Posts