[Julie Madden]

This is driving me nuts cause my Esab Rebel 235 wire feeds too slowly, Using 0.035-inch wire at 22V, and welds is uneven. Can you give me a solution to this?

[Scott Whitaker]

Slow feed comes from bad tension or rollers, Adjust drive roll tension on Rebel 235, My Esab had same issue, Use 230 ipm wire speed, Clean liner with alcohol, Check for wire kinks, Set voltage to 20V, Replace worn rollers.

[Gregory Lopez]

Try looser spool tension, it helps with feeding.

[Michael Salazar]

uneven welds comes from worn drive rolls, Replace them for steady feeding, My Esab feeds smooth now, Check spool tension for balance.

[Vanessa Conrad]

Use 0.030-inch wire, it reduces drag and jamming.

[Denise Perry]

Check liner condition, clogs causes slow feeding.

[Author]

Posts