[Jean Gonzalez]

My MIG weld bead splatters on steel using ER70S-6 wire at 24 volts, beads is messy. Is there any solution?

[Sarah Crane]

Splatter means wrong settings. Lower voltage to 20. Use 0.035-inch wire for control. My beads look clean. Check gas flow at 20 CFH. Clean with alcohol. Use a weave.

[Jeremy Winters]

Miller Multimatic gives better control. Use 0.035-inch wire at 22 volts. My welds look even. Adjust wire speed to 280 IPM.

[Amy Jackson]

Use 300 IPM wire speed.

[Regina Durham]

Practice steady hand. My beads look smoother. Clean with alcohol first.

[Kelly Rogers]

Use anti-splatter spray. My welds stopped splattering. Check gas flow.

[Author]

Posts