welder display blanks out bad

Viewing 4 reply threads
  • Author
    Posts
    • April 25, 2025 at 9:35 am #50681
      Participant
      Dawn Shah

        i am confused cause my YesWelder MIG-250PRO display blanks out at 24 volts, And the screen is dead. Any ideas?

      • April 25, 2025 at 3:52 pm #50683
        Keymaster
        Lauren Wilson

          Blank display is likely a bad board. Check connections and tighten screws, my display came back. Test input power, And clean with alcohol. Contact YesWelder support if it keeps up.

        • April 25, 2025 at 9:47 pm #50684
          Participant
          Megan Miller

            Use a surge protector, It keeps the welder stable.

          • April 26, 2025 at 3:35 am #50685
            Participant
            Stanley Webb

              Reset the welder, my screen works fine after I unplugged it.

            • April 26, 2025 at 11:17 am #50686
              Participant
              Timothy Alvarez

                Bad power is causing blank screen. my YesWelder works with stable voltage.

            • Author
              Posts
            Viewing 4 reply threads
            • You must be logged in to reply to this topic.