[Whitney Delgado]

i am frustrated cause my Miller Multimatic 220 arc pulses weak at 22 volts, And welds is thin. Can you give me a solution to this?

[Scott Whitaker]

Weak pulse is from bad settings. Adjust pulse frequency to 1 Hz, And use 0.035-inch wire. my welds got stronger after that. Clean with alcohol, And check 20 CFH gas. Set voltage.

[Beth Moore]

Use clean steel, It helps the pulse stay strong.

[Mary Phillips]

Check voltage, my Multimatic welds smooth at 22 volts.

[Jane Carney]

Use 280 IPM wire speed, my welds improved a lot after that.

[Author]

Posts