welder wire feed stalls bad

Viewing 3 reply threads
  • Author
    Posts
    • July 28, 2025 at 8:05 pm #69140
      Participant
      Joshua Ramirez

        Hi guys i am annoyed cause my YesWelder MIG-250PRO wire feed stalls bad with 0.035-inch wire, And it stops. What is the fix?

      • July 29, 2025 at 4:07 am #69142
        Moderator
        Aaron Austin

          Feed is stalling cause of bad tension. Adjust roller pressure, my wire feeds smooth now. Check liner for clogs, Use 0.035-inch ER70S-6 wire, And clean with alcohol. Lube the liner too.

        • July 29, 2025 at 12:24 pm #69143
          Participant
          Renee Ochoa

            Replace worn liner, my feed stopped jamming after that.

          • July 29, 2025 at 5:47 pm #69144
            Participant
            Dylan Sweeney

              Check motor voltage with a multimeter, my YesWelder feeds fine now.

          • Author
            Posts
          Viewing 3 reply threads
          • You must be logged in to reply to this topic.