welder arc pulses too weak

Viewing 4 reply threads
  • Author
    Posts
    • July 25, 2025 at 8:55 am #69123
      Participant
      Thomas Ibarra

        i am annoyed cause my Esab Rebel 235 arc pulses too weak on steel at 24 volts, And welds is thin. Any tips?

      • July 25, 2025 at 4:06 pm #69125
        Participant
        Joshua Stafford

          Check voltage, My Esab welds smooth at 22 volts.

        • July 25, 2025 at 9:08 pm #69126
          Participant
          Raymond Barrera

            Weak pulse is from bad settings. Adjust pulse frequency to 1 Hz, my welds got stronger. Use 0.035-inch wire, Clean with alcohol, And check 20 CFH gas flow.

          • July 26, 2025 at 4:43 am #69127
            Participant
            Dorothy Pierce

              Use clean steel, It helps the pulse stay strong.

            • July 26, 2025 at 10:12 am #69128
              Participant
              Melissa Snow

                Use 280 IPM wire speed, my welds got way better after tweaking it.

            • Author
              Posts
            Viewing 4 reply threads
            • You must be logged in to reply to this topic.