Primeweld tig225x spatter on mig welds

Viewing 4 reply threads
  • Author
    Posts
    • April 9, 2025 at 10:29 pm #52875
      Participant
      Jeffrey Adams

        Hi guys i am confused cause my Primeweld TIG225X spatters bad on mig with 0.030-inch mig wire at 20V, welds look messy and rough. any fixes?

      • April 10, 2025 at 6:20 am #52877
        Participant
        Timothy Morgan

          Lower voltage to 18V on your Primeweld TIG225X, use 20 CFH argon, cuts spatter.

        • April 10, 2025 at 2:14 pm #52878
          Participant
          Paula Murray

            Check mig wire quality on your Primeweld TIG225X, bad wire causes spatter, use 230 ipm.

          • April 10, 2025 at 7:32 pm #52879
            Participant
            Sherry Valdez

              Clean liner with alchohol on your Primeweld TIG225X, dirty liners cause spatter, check tip.

            • April 11, 2025 at 2:52 am #52880
              Participant
              Steven Underwood

                Use anti-spatter gel on your Primeweld TIG225X, helps reduce spatter, set wire speed to 220 ipm.

            • Author
              Posts
            Viewing 4 reply threads
            • You must be logged in to reply to this topic.